Miniatures: Dropzone Commander - Scourge:Oppressor

As you can't/shouldn't only build the new transport you specifically bought to transport your new commander unit, I built the oppressor shortly after the Harbinger.

The Packaging

So as mentioned in previous posts the model comes in a easy to open blister. Inside the blister you'll find the model, some firm foam and card inlay.


The model

Top

bottom

The model consists of 11 parts: Body, 6 legs, 2 plasma carbines (2 on right in picture) and 2 electroweb casters (attached to strip of resin)

Once again Hawk doesn't disappoint with this model, as it beautifully detailed. Both the top and the bottom are very detailed, bringing excitement at the painting potential.

 Building the model

Top down 

Underneath

At first glance I thought this model would be difficult to build what with all the parts however it was actually really easy.

Firstly I had to tidy it up and remove the flash. There wasn't too much, granted more than the Harbinger but as the excess is resin it cuts of easily and quickly.

I glued the legs on first using superglue, making sure that they aligned so when it's placed on the table it doesn't wobble, fall over or look stupid. After that I admittedly had to consult the internet to check where the plasma carbine and electroweb casters went. After a quick google image search I find the picture and applied the weapons correctly.

That was it! from blister opening to fully built in less than 10 minutes!